I don't know if I'm the
only one, but every time I have an idea for something, it usually
involves spending money on new supplies. So wherever possible, I like
to save my pennies and come up with alternatives to expensive
shop bought products. It's also good for some instant gratification
as quite often, by the time something has arrived, I'm off on a new
idea and the new tool sits in it's packet until I get back around to it.
Something I use a lot
of is cutters. I have lots of favourite shapes and sizes, but
sometimes, I either can't find what I need, or it just isn't
available in the size I want. So I make my own.
To start, you need a
can of fizzy drink. Drink the contents and wash out the can and leave
to dry.
Now for the safety side
of things...
*Warning... Cutting cans can leave very sharp edges, I
recommend you wear gloves if making cutters using this method!
So with your gloves on!
Take a sharp knife and carefully cut around the can, removing the top
and the bottom. You should be left with a cylinder of metal. Slice
down this with scissors so you have a sheet of metal.
Flatten it out and cut
in to strips. I make mine between ½ – 1 inch depending on the size
of the cutter. If it's going to be a small cutter, don't make it too
deep, as you need to be able to poke your clay out to remove it.
Bend the metal in to
the shape you want. To make sharp corners, use a pair of flat pliers
to bend the metal to whatever angle you need. Don't pinch corners too
tightly, as the metal is quite thin, it will split along the edge and
spoil your cutter.
Make sure the bottom
edges line up, it doesn't matter too much about the top, and use
sticky tape to secure them folding it over the top edge. It's a good idea to put tape around the
top rim of the cutter too to give your fingers a bit of protection
while you're using them.
Use them as you would
your normal cutters. They are a little more flimsy than shop bought, and you might need to smooth your clay back in to shape a little bit before drying/baking, but you should get plenty of use out of them before they need
replacing!
Happy cutting!
Caroline
