Thursday, February 26, 2015

Reprise - Flower Tendril Earring Tutorial


\I don't know about you but I've had enough of winter for this year and I'm eager for spring to arrive. There don't seem to be many early flowers making an appearance yet - I've seen one lonely daffodil but not much else so to brighten things up I thought I'd reprise my tutorial for these flower tendril earrings...a quick an easy way to get yourself ready for a new season.


To make these you will need two 8" lengths of 19/20 gauge wire, 2 flower beads or similar flat disc beads with reasonably small holes and 1 pair of ear wires. You'll also need a hand torch, wire cutters,  round and needle nose pliers, looping pliers or other round tool and a file.


Please excuse the state of my hands in these photos - much neglected at the best of times and not helped by my thumb having a mishap with a door hinge at the weekend!

Step 1
Using the hand torch ball up the ends of the wires so that they won't pass through the holes in the beads. You can find a tutorial for doing this here. This should also soften the wire and make it easier to bend. I've left the fire stain on the wire but you can clean them up at this point if you want to.


Step 2
Pass a wire through the a bead from front to back and with your thumb on the ball at the front bend the wire up and press gently against the back of the bead.


Step 3
Where the wire comes out of the back of the bead bend it into a loop using looping pliers, mandrel  or a round object like a sharpie marker.


The loop should be visible above the top of the bead.



Step 4
Take the end of the wire and pass it between the bead and the loop over the wire where it comes through the bead then gently pull it down to form a vertical tail. Keeping your thumb pressed at the point where the 2 wires meet while wrapping will help ensure the wire is snug.


Step 5
Trim the excess wire to 2 1/2 to 3 inches from the bead centre, file the end flat and remove any burrs.


Step 6
Using round nosed pliers make a turned loop at the bottom of the wire and then continue winding the wire up the pliers towards the jaws until you get to the bottom of the bead.


Step 7
Remove the round nose pliers and you will have a graduated coil. Use the needle nose pliers to bend the coil down so it sits vertically beneath the bead and loop.


Step 8
Insert the needle nose pliers into the loop at the bottom of the coil and grip the wire. Holding the bead and loop between forefinger and thumb to avoid stressing the bead, pull firmly but gently on the wire. The coil may open up nearest the bead at first and which point it may help to hold the wire there while pulling further on the lower end. Close up the loops at the bottom of the tendrils and file/polish out any tool marks.



Step 9
Repeat steps 1 to 8 to make the second earring and then use your pliers to gently adjust the coils to roughly match if necessary.

Step 10
Add your ear wires and treat with any desired patina and there you have your finished earrings!


All the beads used in the earrings shown here are from Mermaid Glass.

Hope you enjoyed this tutorial and feel inspired to try it yourself.

Lesley

The Gossiping Goddess

3 comments :

  1. What a lovely design! The spirals add that extra something special and unique. Thanks for the tutorial, it definitely brightened up this snowy day!

    ReplyDelete
  2. I thought this tutorial was great the first time...and love it still!

    ReplyDelete

We would love to hear what you have to say, please leave a comment.